88 search results - page 13 / 18 » Design for manufacturability in submicron domain |
WETICE
1998
IEEE
13 years 11 months ago
1998
IEEE
This paper describes the architecture and concept of operation of a Framework for Adaptive Process Modeling and Execution (FAME). The research addresses the absence of robust meth...
CAD
2005
Springer
13 years 7 months ago
2005
Springer
3D CAD is replacing 2D CAD to improve efficiency of product design and manufacturing. Therefore, converting legacy 2D drawings into 3D solid models is required. CSG based approach...
CAGD
2004
13 years 7 months ago
2004
Topologically consistent algorithms for the intersection and trimming of free-form parametric surfaces are of fundamental importance in computer-aided design, analysis, and manufa...
KDD
2004
ACM
14 years 27 days ago
2004
ACM
Part numbers are widely used within an enterprise throughout the manufacturing process. The point of entry of such part numbers into this process is normally via a Bill of Materia...
SDM
2009
SIAM
14 years 4 months ago
2009
SIAM
Automotive companies are forced to continuously extend and improve their product line-up. However, increasing diversity, higher design complexity, and shorter development cycles c...