IJWIS
2006
13 years 11 months ago
2006
The World Wide Web has undergone a rapid transition from the originally static hypertext to an ubiquitous hypermedia system. Today, the Web is not only used as a basis for distribu...
WSC
2001
14 years 27 days ago
2001
The use of simulation in healthcare area is not widely spread when compared with other areas. This paper suggests that traditional approaches to modeling may not fully utilize sim...
WSC
2007
14 years 1 months ago
2007
Conceptual modeling, deciding what to include in the model, is a very important task in the modeling process. However, it has so far received relatively little attention in the li...
AGENTS
2001
Springer
14 years 4 months ago
2001
Springer
The agent-oriented modeling process is divided in a typical sequence of activities, i.e., requirements specification, analysis, and design. The requirements are specified by des...
DATE
2002
IEEE
14 years 4 months ago
2002
IEEE
This paper addresses the development of accurate and efficient behavioral models of digital integrated circuit input and output ports for EMC and signal integrity simulations. A ...
SCESM
2006
ACM
14 years 5 months ago
2006
ACM
Requirements models for large systems typically cannot be developed in a single step, but evolve in a sequence of iterations. We have developed such an iterative modeling process ...
ICSEA
2006
IEEE
14 years 5 months ago
2006
IEEE
A modeling process is presented for extracting timingaccurate simulation models from complex embedded realtime systems. The process is supported by two complementary methods for t...
SG
2007
Springer
14 years 5 months ago
2007
Springer
For the generation of freeform 3D models, one of the most intuitive solution is to use sketch-based modeling environments. Unfortunately, since the user interface relies upon the a...
SARA
2007
Springer
14 years 5 months ago
2007
Springer
Though there exist some rules of thumb for design of good models for solving constraint satisfaction problems, the modeling process still belongs more to art than to science. Moreo...