Sciweavers

430 search results - page 70 / 86
» Power Optimized Combinational Logic Design
Sort
View
TMC
2012
11 years 11 months ago
E-MiLi: Energy-Minimizing Idle Listening in Wireless Networks
WiFi interface is known to be a primary energy consumer in mobile devices, and idle listening (IL) is the dominant source of energy consumption in WiFi. Most existing protocols, s...
Xinyu Zhang, Kang G. Shin
DAC
2006
ACM
14 years 10 months ago
Extending the lifetime of fuel cell based hybrid systems
Fuel cells are clean power sources that have much higher energy densities and lifetimes compared to batteries. However, fuel cells have limited load following capabilities and can...
Jianli Zhuo, Chaitali Chakrabarti, Naehyuck Chang,...
ICCAD
2008
IEEE
89views Hardware» more  ICCAD 2008»
14 years 5 months ago
Temperature aware task sequencing and voltage scaling
Abstract—On-chip power density and temperature are rising exponentially with decreasing feature sizes. This alarming trend calls for temperature management at every level of syst...
Ramkumar Jayaseelan, Tulika Mitra
SLIP
2003
ACM
14 years 2 months ago
Error-correction and crosstalk avoidance in DSM busses
Aggressive process scaling and increasing clock rates have made crosstalk noise an important issue in VLSI design. Switching on adjacent wires on long bus lines can increase delay...
Ketan N. Patel, Igor L. Markov
DAC
2000
ACM
14 years 10 months ago
The use of carry-save representation in joint module selection and retiming
Joint module selection and retiming is a powerful technique to optimize the implementation cost and the speed of a circuit specified using a synchronous data-flow graph (DFG). In ...
Zhan Yu, Kei-Yong Khoo, Alan N. Willson Jr.